Bent Oil Connector 18.8

Bent Oil Connector 18.8 - turn your bong into a dab rig

With the 3-piece Heisenberg Bent Oil Connector you can turn your glass bong for herbs into a bong for oil and extracts. The compact bong extension set consists of an angled adapter piece with a double male 18 8 ground glass joint, a glass nail and a glass dome with a female 18 8 ground glass joint.
Due to the angle of the adapter piece, the Bent Oil Connector is fundamentally suitable for bongs and bubblers that have an angled ground joint such as a large number of different beakers.

How to use the Bent Oil Connector

Prepare your bong/bubbler for use by filling it with water until the percolators or respective chillum are far enough under water. Then proceed step by step to the perfect dab.

1. Insert the 18 8 adapter piece into the ground joint sleeve of the bong of your choice, or into the ground joint sleeve of the chillum.
2. Take the glass nail and carefully slide it through the upper part of the male ground joint. The nail will be kept from falling through the adapter because of the glass parts on the side.
3. Heat the nail with a jet lighter or a Bunsen burner. Take the oil dome and carefully place it on top of the adapter piece.
4. Using a glass or metal dabber, drip your extract through the opening of the dome onto the nail. The dome helps you to condense the vaporising extract inside. Start inhaling while you do this to avoid wasting any extract.

Tip: With a carb cap you can keep the heat of the nail better to do low temp dabs. It's even easier with a carb cap dabber, because you have to work with fewer accessories at the same time.

Scope of delivery:
- 1x Oil Dome 18.8F
- 1x Bent male to male adapter, 2x 18.8M
- 1x Glass nail